Zhuangyuan brand piston heating equipment is used for piston heating in power machinery equipment assembly line, such as internal combustion engine, diesel engine, etc. The purpose is to make the piston bore and the piston pin interference assembly, after the assembly of the piston bore natural cooling, shaft and pin tightly hoop together, with close.

Using the principle of power frequency induction to heat the piston pin hole quickly has the advantages of fast heating speed, simple and convenient operation, safe and pollution-free, and continuous heating. Compared with the oven, it can greatly save electric energy and operate while heating, so as to achieve the best cooperation effect between human and machine.

Structure:

The piston heater is divided into two or three station combined type, which is composed of two or three induction main engines, including main engine, electric control box and power cabinet.

The domestic well-known enterprises are Yuchai, Dongfeng, FAW, etc

The picture above shows the installation site of the heated piston, pin and retaining ring. The worker is busy in the assembly. Zhuangyuan brand piston heating equipment works in diesel engine production line, with more than ten years of service life, almost trouble free quality assurance, continuous and non-stop cycle operation, demonstrating the excellence of brand and quality.

Debugging and operation:

1. check whether the power supply wire and heating equipment are well wired, and the grounding shall be reliable and firm, and the Yitie shall be in good agreement after being placed.

2. Turn on the power switch, turn the selection switch to the required position, and turn on the switch of the electric cabinet. At this time, the red light will be on.

3. Put the piston in the iron and put it in the middle of the end face of the iron core of the main engine, and adjust the time relay to the required number of seconds.

4. Start the main engine for heating, when the green light is on, the piston is heated. When the piston is heated to the set time, the heating will stop automatically, and the rocker arm can take off the heated piston to wear the sleeve pin. It can be heated continuously.